Description
9″ Rear with Axles, Wheel Studs & Bearings
New Center Fabricated Can (STANDARD)
Internal Housing Gussets (STANDARD)
3″ – .250″ Wall Tubes (STANDARD)
Housing Studs Installed (STANDARD)
Comes with 10 Center Section Nuts & Vent (STANDARD)
Mono Leaf Pads (STANDARD)
Your choice of 28 – 31 – 35 Spline Axles (STANDARD)
1/2″ Wheel Studs 2″ or 3″ (STANDARD)
Options
Cal-Track Pads available
Many Housing End Choices
Bearing Retainer Options
Back Brace
Fill & Drain
T-Bolts
Brake Options
Powder Coating
Wheel Stud Upgrade to 5/8″
Important information:
When selecting “differential options” – This is telling us what center section that you already have or are planning on using. The axle lengths will be cut accordingly. If you purchase this for a spool, then later down the road want a clutch lock, S-trac or True Track, etc., etc. – one axle may not fit & will need to be trimmed down. Or if you bought this for anything but a spool, & then use a spool center section, the axle could end up being too short on one side. You will not have enough spline engagement.
Reviews
There are no reviews yet.